CAN Adapters

ID #1097

What to do if Error LED is permanently on?

If the Error LED is permanently on and bit 7 of the status byte is set, then VSCAN device has detected a Bus Error. The most usual cases are:

  • wrong bitrate, i.e. your VSCAN device uses other bitrate than the target CAN device
  • wiring is wrong, checkif you all tree wires (CAN_H, CAN_L and GND) are properly connected and terminated with necessary resistor values

Tags: -

Related entries:

Last update: 2013-06-13 15:57
Author: Support
Revision: 1.1

Digg it! Print this record Send to a friend Show this as PDF file
Please rate this entry:

Average rating: 1 out of 5 (1 Votes )

completely useless 1 2 3 4 5 most valuable

You cannot comment on this entry